Hola estoy haciendo el proyecto fin de carrera con el micro AT89c51ac3.
¿Qué valor de corriente tengo que tomar para dimensionar los componentes que se encuentran alrededor de los pines?
He leido las características eléctricas del micro y hay una parte que no me ha quedado muy clara. A ver si hay alguien que pudiera explicármelo gracias.
"Under steady state (non-transient) conditions, IOL must be externally limited as follows:
Maximum IOL per port pin: 10 mA
Maximum IOL per 8-bit port:
Port 0: 26 mA
Ports 1, 2, 3 and 4: 15 mA
Maximum total IOL for all output pins: 71 mA
If IOL exceeds the test condition, VOL may exceed the related specification. Pins are not guaranteed to sink current greater
than the listed test conditions"
¿Qué valor de corriente tengo que tomar para dimensionar los componentes que se encuentran alrededor de los pines?
He leido las características eléctricas del micro y hay una parte que no me ha quedado muy clara. A ver si hay alguien que pudiera explicármelo gracias.
"Under steady state (non-transient) conditions, IOL must be externally limited as follows:
Maximum IOL per port pin: 10 mA
Maximum IOL per 8-bit port:
Port 0: 26 mA
Ports 1, 2, 3 and 4: 15 mA
Maximum total IOL for all output pins: 71 mA
If IOL exceeds the test condition, VOL may exceed the related specification. Pins are not guaranteed to sink current greater
than the listed test conditions"